Description
- Bumpers are for RemsBoard only. Will not fit the Masterpoint!
- RemsBoard Bumpers are two strips of birch plywood, beautifully finished with felt pads on one side and pressure sensitive adhesive Velcro on the other. To assemble:
- Peal off the protective backing from both sides of one protective board.
- Center the protective board on the back of the RemsBoard at the top, slightly below the top edge. Press the protective board down firmly onto the back of the RemsBoard.
- Repeat with the second protective board a the bottom of the RemsBoard.
The glue on the Velcro take 24 hours to achieve full strength. Do not remove the protective boards until the glue has had time to set.
Not for use while climbing. The Remsboard is designed for a ground-school setting, where there is no fall consequence. Climbing, mountaineering and all technical rope work are potentially hazardous activities and cannot be made safe. Always seek professional instruction from qualified guides or instructors, taking personal responsibility to learn the proper techniques involved, assuming all risks and accepting full responsibility for injuries, loss or death.
Not for use while climbing. The Remsboard is designed for a ground-school setting, where there is no fall consequence. Climbing, mountaineering and all technical rope work are potentially hazardous activities and cannot be made safe. Always seek professional instruction from qualified guides or instructors, taking personal responsibility to learn the proper techniques involved, assuming all risks and accepting full responsibility for injuries, loss or death.
Reviews
There are no reviews yet.